System information

4. If necessary, change the Constrain Angle (for SHIFT-rotate) or the Cross Hair Color in the
Enfocus Inspector. You can change the Cross Hair Color by clicking the color patch and selecting
a different color.
Note: In the Numeric Feedback area you can find exact information about the rotating action
you are about to perform.
5. Click the selected object.
The object’s point of origin around which it will be rotated is indicated.
Figure 28: The point of origin is in the center of the selected object.
6. Do one of the following:
• To rotate the object around its center point, drag the selected object in a circular motion.
Figure 29: Rotating an object around its center point.
• Double-click on another position to move the point of origin. Move the pointer away from
the center point and drag in a circular motion to rotate the object around its new point of
origin.
Figure 30: Rotating an object around its point of origin placed outside the object.
• Hold down the SHIFT key while dragging to rotate the object in fixed angles. You can set this
angle in the Numeric Feedback category of the Enfocus Inspector dialog box.
127
Enfocus PitStop Pro