Specifications

34
D O I T Y O U R S E L F
ENGINE - OIL CHANGE
Secondary
Drain Plug
Primary
Drain Cap
Primary
Drain Bolt
(Refer Periodical Maintenance Chart for frequency)
 Place motorcycle on its center stand on a firm flat
surface.
 Start engine and warm up for 2 minutes.
 Keep a clean tray below the engine
 Remove primary drain cap, to drain oil & clean
suction filter, magnet.
 Then remove secondary drain plug to drain oil &
clean the magnet.
 Finally remove primary drain bolt to drain the
complete oil.
 Remove the oil filter element on the Crankcase
Cover RH.
 Allow the oil to drain by tilting the motorcycle to
both sides.
 Wash the drain pl ug and the suction fil te r
thoroughly and refit on the crankcase after all the
oil is drained out.
 Soak a new oil filter element in the oil and refit on
the Crankcase Cover RH.
 Assembly 3 bolts and tighten them. Ensure ‘O’
Ring and gaskets are taken seat properly.
NOTE :
Replace oil f il te r e le ment whenever oil is being
replaced.
CAUTION :
Filling up oil over “MAX” mark may cause smoke and
/ or loss of power. Do NOT allow oil level to fall below
“MIN” mark. Doing so may result in engine internal
damage or malfuncton.

Fill recomme nded oil to
engine till the oil level is
upto “MAX” level mark in
the oil window in Crank-
case Cover RH.
Max
Min