Specifications

34 Solution3.4InstallationandOperationManual
8 THEFLUESYSTEM
8.1 GENERAL
The flue system, made up of the flue system and the flue between the wood fire and the flue
system,actsastheenginethatdrivesyourwoodheatingsystem.Eventhebest woodfirewillnot
functionsafelyandefficientlyasintendedifitisnotconnectedtoasuitablefluesystem.
Theheatinthefluegasesthatpassfromthewoodfireandflue intothefluesystemisnotwaste
heat.Thisheatiswhatthefluesystemusestomakethedraftthatdrawsincombustionair,keeps
smokeinsidethe woodfireandsafely ventsexhaustto outside.Youcanthink ofheatinthe flue
gasasthefuelthefluesystemusestomakedraft.
8.2 SUITABLEFLUESYSTEMS
Your wood fire will provide optimum efficiency and performance when connected to a 150 mm
diameter flue system. The crosssectional area of the flue shall be within 20 percent of the flue
collaropening
Tobesuitable,afactorybuilt InsulatedFlueKit
must comply with AS/NZS 2918 Appendix F or
AS/NZS2918AppendixB.
8.2.1 FACTORYBUILTINSULATEDFLUEKITS
Factory built flue kits are normally sold as a
complete system, (not just the flue pipe), with
all the components needed to install a heater
into a normal 2.4 metre (8 foot) timber stud
wall, low pitched roof home. Each flue kit
should contain aset ofinstallation instructions
coveringallthecomponentssuppliedinthekit.
Incorrect installation of these kits is a major
source of post installation problems and no
short cuts should be taken. All components
supplied in the kit are required and should be
used to
ensure the installation is correct and
safe. It is essential the flue pipe is
manufactured from stainless steel that meet
the specifications stated in AS/NZS 2918, as
stainless steel can be damaged by excessive
stress in thelock forming processor byfaulty
machinery.