Installation manual

34
2.8 DOOR ALIGNMENT
To adjust the door positioning and spacing, loosen the hinge screw and pivot the hinge until
the door is in the correct position. To tilt the door, lock in place one of the two hinges and
pivot the other. The door will tilt to one side or the other depending on the direction the hinge
is pivoted. For the door to be straight, both hinges must be aligned along the same axis.
If the door hinges are misaligned, it will tilt. It is therefore recommended to align them. Once
the ideal position has been achieved, lock the hinges in place by tightening the hinges screws.
Adjust the pressure on the gasket using the centre adjustment screw located at the bottom of
the combustion chamber. To check the pressure applied, place a slip of paper between the
door and the face, and pull gently. You should feel a slight resistance.
Figure 35