Owner`s manual

PRODUCT INFORMATION
4External Roof-mounted Power Vent System EuropeanHome.com
Thank you for purchasing an Internal Power Vent System (IPVS) by European Home. This system combines two great hearth
product names; European Home and Enervex®. Where necessary, excerpts of the Enervex installation instructions are inserted into
this manual and labeled with:
OVERVIEW
The IPVS is approved for use with the entire line of Element4 replaces and must be mounted internally and used with wall-
mounted terminations ONLY. The IPVS consists of six main components:
1. a PV-GS-SGV-01 solenoid valve
2. a PV-WM-AS air separator (2 req’d.; PV-WM-FAS-01 and PV-WM-MAS-01)
3. a PV-GS-CM-ADC 100 system control with included PDS 1 proven draft switch
4. a PV-WM-146 power vent
5. a PV-ES-PLS-WHT-02 system switch
6. an E4-SA-WS-80 ame switch
7. an installation manual
The PV-WM-146 fan, which creates negative pressure within the venting, is mounted between two PV-WM-AS separators, one of
which is mounted directly to the outside wall of the building. Inside of the building, the PDS 1 proven draft switch senses the draft
pressure and signals the system controller. Once the draft has been established the solenoid valve is opened, the ready light is lit
and the replace can be operated as usual.
The above components are all connected by customer-supplied wiring which must be in accordance with the requirements of the
authority having jurisdiction or, in the absence of such requirements, with the National Electrical Code, NFPA70.
The installation of your IPVS will follow the steps below and this manual is laid out accordingly.
• Installing the Fan and Fan Controls
• Installing the Solenoid Gas Valve
• Testing the System
ENERVEX®
As sold, the Enervex® components may be installed to accommodate a number of dierent replace
models and types. However, when installed with an Element4 replace from European Home the Enervex®
instructions excerpted in this manual are to be followed exclusively.