Specifications

3000270 05.12

Bolt

3.7 Wall Mounting of Chimney Fan

When mounting the chimney fan on a wall, the installation

instructions for installation on a steel chimney should be followed.

Use of the adapter SCA can make the installation easier, but is not a

requirement.

To ease installation, detach the fan base by removing the bolts

holding the hinges together. Center the fan base over the outlet and

bolt the base onto the wall with the hinges pointing upwards.

After mounting the base securely, attach the fan motor housing by

  reassemblingthefanhinges.Sealwithsiliconeallaroundtheber 

  mattopreventrainfromenteringtheue.

3.8 Installation of Proven Draft Switch (PDS)

A safety system must be interlocked with the appliance(s). The

safety system could utilize a Proven Draft Switch, a thermal switch

  oraowswitch.Thedevicemustbeinterlockedwiththeheating 

  appliancesoitshutsdownincaseofinsufcientdraft,fanfailureor 

power failure. Please refer to the PDS Installation Manual if this

control is used.

For more information on alternative safety systems, please contact

ENERVEX, Inc.

  ThegureshowsthelocationoftheprobeforthePDS.Locationis 

important to make sure there is enough pressure or draft available

for the switch to work.

A safety device that prevents the heating appliance

operation, in case of a power failure or inadequate

draft situation, must be installed.