Specifications

7
3000270 05.12
3.3 Single Fan on Brick Chimney
Step 1: Prepare fan location
 Theinstallationprocedureisthesamewhethertheueisroundor 
 square.Ifaclaytileuelinerisinstalled,itmightstickupafew 
 inches.Cutitbacksoitisushwithornomorethan1/2inchabove 
the chimney crown.
 Measuretheinsidediameteroftheue,cutacorrespondingholein 
 thebermatleavingaminimumdistanceof3/4”toanysideof 
 thebermat.
 Thealuminumfoilonthebermatmustfaceupwards(againstfan 
base).
Step 2: Preparation of fan
Locate the installation brackets in the grooves on the underside of
the fan base using the bolts and nuts supplied to secure the
brackets. Note that the bolts shall be installed from the bottom side
in the two inner holes.
 Adjustthenalpositionofthebracketsensuringthatthereis 
 clearancebetweenthebracketsandtheuewall.Ifthebrackets 
touch the wall, it may generate some vibration noise.
Step 3: Attaching the fan
The chimney fan is now ready for installation on the top of the
 chimney.Placebermatwiththealuminumfoilfacingupwardson 
the top of the chimney, and place the fan on top of the mat.
High temperature silicone can be applied on the side of the mat,
but is not required. It can also be painted. It is not necessary to bolt
the fan to the chimney.
Caution: Under conditions with extremely
strong winds surrounding the top of the
chimney, the chimney fan must be secured by
steel wires supplied with the fan.
!