Specifications

6
3000270 05.12
3. Mechanical Installation
3.1 Transport Safety Device
If a transport safety device is present, remove it from the vane and
make sure that the vane can revolve without hindrance.
RS 14/16: Before mounting, the transport safety device on the
hinges must be removed.
3.2 Single Fan on Steel Chimney
Step 1: Prepare fan location
If a stack cap is already installed, it must be removed. The steel
chimney adapter (SCA) slides right into the chimney, where the long
collar engagement ensures safe anchoring. If necessary,
the adapter can be secured by means of long self-tapping stainless
steel screws into the side of the collar through the chimney wall.
If the steel chimney is air cooled, a special adapter for
such chimney must be used.
 Measuretheinsidediameteroftheueandcutacorrespondinghole
 inthecenterofthebermat.Iftheueissobigthatthethroatin 
 theadapterhasbeenreducedtotthethroatofthefan,theholein 
 thebermatshouldcorrespondtothethroat.
 Thealuminumfoilonthebermatmustfaceupward(againstfan 
base).
Step 2: Preparation of fan
Locate the installation brackets in the grooves on the underside of
the fan base, using the bolts and nuts supplied to secure
the brackets. Note that the bolts shall be installed from the
bottom side in the two inner holes.
 Adjustthenalpositionoftheinstallationbracketsensuringthat 
 thereisasmallgapbetweenthebracketsandtheuewall/adapter 
 throat.Tightenthenuts.Ifthebracketstouchtheuewall,it 
may create some vibration noise.
Step 3: Attaching the fan
The chimney fan is now ready for installation on the top of the
 chimney.Placethebermatwiththealuminumfoilfacing  
upwards on the top of the adapter, and place the fan on top
of the mat. High temperature silicone can be applied on the
side of the mat, but is not required. It can also be painted. It
is not necessary to bolt the fan to the chimney.
Caution: Under conditions with extremely
strong winds surrounding the top of the
chimney, the chimney fan must be secured by
steel wires supplied with the fan.
!
!