User guide

6
8.0 MAINTENANCE/ SERVICE
Regularly inspect all components to detect
any problem requiring service and maintenance.
To prolong the life of your Enerpac equipment, follow
points below:
• Always clean and lubricate after usage.
• Clean and grease contact surface between wedge
and jaws with high quality grease (Molykote).
• Grease the pins (No. 5)
• Keep pushrod (No. 9 of FSM-8) clean.
No. Description Qty. Part No.
1. Wedge 1 EN300101
2. Jaws 1 set of 2 EN300201
3. Thrust Bearing Assy. 1 EN301802SR
*4. Set Screws 1 set of 4 *
*5. Pins 1 set of 4 *
6. Male/Female
Coupling 1 EN301901
7. Handle 1 EN302001
No. Description Qty. Part No
1. Wedge 1 EN300101
2. Jaws 1 set of 2 EN300201
3. Connector 1 EN300301
*4. Set Screws 1 set of 4 *
*5. Pin 1 set of 4 *
*6. Handle Screw 1 *
7. Handle 1 EN300701
No. Description Qty. Part No.
*8. Base Screw 1 set of 2 *
9. Female Coupler 1 CR-400
10. Cylinder 1 RC-102
11. Body 1 EN301101
*12. Split Pins 1 set of 8 *
*13. Set Screws 1 set of 2 *
14. Safety Block 1 SB1**
No. Description Qty. Part No.
8. Circlip 1 EN302101
9. Pushrod 1 EN301802SR
11. Body 1 EN301101
*12. Split Pins 1 set of 8 *
*13. Set Screw 1 set of 2 *
14. Safety Block 1 SB1**
15. Spanner 1 SW22**
1� �
*13
2
*12
*4
*5
11
2
*12
*4
7
6
8
9
15
14
*5
3
2
3
*4
*4
11
10
9
*8
14
7
*5
*5
*6
1
*12
*12
*13
10.0 PART LIST FSM-8
9.0 PART LIST FSH-14
Note: Items marked * supplied in Repair Kit FS-148K
** Accessory Item
Note: Items marked * supplied in Repair Kit FS-148K
** Accessory Item