User Manual

8.0 VERTICAL OPERATION
The set-up and operation of ATM-4 in the vertical
position remains the same as steps 1 thru 5 in
section 6.0 (see Fig. 15).
Fig. 15
USING THE ATM-4 ON A
VERTICAL LINE
9.0 DISMANTLING THE ATM-4
• Oncealignmentisachieved,allworkonthejoint
finished,andbolt-upcompleted(apartfromthe
boltholeinwhichtheATM-4ishoused),thetool
canbedismantledbyreversingsteps1thru5in
paragraph 6.0.
• Care should be taken not to drop any of the
component parts when removing them from the
aligned joint. This action will prevent injuries to
either the operator’s lower limbs, or to passers-
by.
10.0 INSPECTION AND EXAMINATION
• After finishing the job and before the ATM-4 is
placedbackintoservice, the completeness of the
toolmust be establishedand items examinedto
ensurethattheyareserviceable.
• Anymissingordamageditemsaretobereplaced
as soon as possible and prior to the tool being
used again.
• GreaseallmovingpartsregularlyRefertosection
12.0,LubricationandMaintenance.
• Ensurerollersandpinsremaingritfree.
• Returnallitemstothecarryingcasewhennotin
use.
11.0 STORAGE
• TheATM-4shouldbestoredinacooldryplace.
• Machined surfaces are to be smeared with
Mobilgrease XHP™ 222 Special grease or an
equivalentgoodqualityhighloadbearinggrease.
12.0 LUBRICATION AND MAINTENANCE
Use Mobilgrease XHP™ 222 Specialgrease or an
equivalent goodqualityhighloadbearinggrease .
Maintaining the Tool
Alwaysensurethescrewboltislubricatedbeforeuse.
Thiswillenhancethetool’sperformanceandlifetime.
On the base of the screw bolt within the swivel
is housed a thrust bearing which should be free
runningandlubricatedregularly.
Set the torque wrench to the lowest setting after
each use and for storage.
Cleaning and lubrication of internal parts
(see Fig. 16)
STEP1. Placetooluprightonaworkbench.
STEP2. Using a flat blade screwdriver, lever out
the end of each spiral clip. Then, rotate
themcounterclockwisetoremove.
STEP3. Slidetherollershaftsoutinordertoremove
therollersandbearingsforexamination.
STEP4. Inspecttherollershafts,rollersandbearings
fordamage.Ifthereisnodamagepresent,
they can then be cleaned, greased and
reassembled(reversesteps1through3).
Fig. 16
SPIRAL
CLIPS
ROLLER
SHAFTS
ROLLER
NEEDLE
BEARING
ROLLER
NEEDLE
BEARING
6