User Guide

4. Remain still. The red LED should not flash. The lights should turn off after 15

The sensors are factory preset to allow for quick installation in most applications.

Verification of proper wiring or coverage, or customizing the sensor’s settings

can be done using the following procedures. To make adjustments, open the

Front Cover with a small screwdriver.

1. Ensure the PIR Activity is enabled, red LED flashes, and PIR Sensitivity is set

2. Ensure the Time Delay is set for Test Mode

to MAX (DIP switch 1 OFF).

3. Ensure that the Light Level is at the maximum position.(see" LIGHT LEVEL

seconds. (If not, see “TROUBLESHOOTING.”)

5. Move about the coverage area. The lights should come on.

When testing and adjustment is complete, reset DIP Switches,Time Delay and

Light Level to the desired settings, and replace the cover on the sensor.

ADJUSTMENT”)

Sensor Test:

Refer to the Figure 8 above

Note:

There is a 40- second warm-up period when power is first applied.

PIR lens

PIR Activity LED(Red)

Light level Adjustment

Double gang mudring

mounting holes

DIP switches

Keyhole slots(for mounting to

4" octagonal box)

TEST

Min

Time Delay Adjustment

Light

Figure 4

Sensor Adj ustment