Installation Manual

WARRANTY INFORMATION
This device is warranted to be free of material and workmanship defects for 2 years from the
date of purchase. Original receipt or proof of purchase from an authorized retailer must be
presented upon warranty claim. ALL claims must be verified and approved by Enerlites, Inc.
Warranties from other Enerlites products may vary. This warranty is nontransferable and
does not cover normal wear and tear or any malfunction, failure, or defect resulting from
misuse, abuse, neglect, alteration, modification, or improper installation. To the fullest extent
permitted by the applicable state law, Enerlites shall not be liable to the purchaser or end
user customer of Enerlites products for direct, indirect, incidental, or consequential damages
even if Enerlites has been advised of the possibility of such damages. Enerlites’ total liability
under this or any other warranty, express or implied, is limited to repair, replacement or
refund. Repair, replacement or refund are the sole and exclusive remedies for breach of
warranty or any other legal theory.
4 5 6
© 2016 Enerlites Inc.
CA, U.S.A.
WWW.ENERLITES.COM
0206160022-02
SELECT THE OPERATING MODE
The Digital Timer has 2 operating modes:
Manual (MAN) and Automatic (AUTO). To
switch modes, open the control panel door and
press the MODE button until the desired mode
is displayed.
Automatic Mode
On the main screen, "AUTO" mode will be
displayed when switch is in AUTO mode along
with the current state of the Load (ON or OFF).
In this mode, the Timer WILL turn the lights
ON/OFF according to the programmed times
regardless of whether the Load is ON or OFF.
Manual Mode
On the main screen, "MAN" mode will be
displayed when switch is in MANUAL mode
along with the current state of the Load (ON or
OFF). In this mode, the Timer WILL NOT turn
the lights ON/OFF automatically.
PROGRAMMING (Cont.)
DELETING a Program:
• Press PROG button until the ON or OFF program you wish to
delete is displayed.
• Press the RCL button. The program is now deleted. Remember
to delete each OFF program for every ON program and vice
versa.
• When you are done deleting the undesired programs, press the
MAN button or close the switch door to return to the main screen.
Daylight Savings Time (DST):
• To Enter Daylight Savings Time, press and hold down the HOUR
(DST) button for five seconds while you're in the main screen. You
are now in DST and "DST" will be displayed on the LCD screen.
• To Exit Daylight Savings Time, press and hold down the HOUR
(DST) button for five seconds while you're in the main screen. You
are now in Standard Time and "DST" is no longer displayed on the
LCD screen.
Random Progam mode:
This Timer has a Random Mode that may be used as a safety
feature. While in Random Mode, the Timer will randomly turn the
lights ON within a 30 minute window of each programmed ON time
and randomly turns the lights OFF within a 30 minute window of each
programmed OFF time.
• To Enter Random Mode, press and hold down the MIN (RND)
button for five seconds while you're in the main screen. You are
now in Random Mode and "RND" will be displayed on the LCD
screen.
• To Exit Random Mode, press and hold down the MIN (RND)
button for five seconds. You have exited Random Mode and
"RND" is no longer displayed on the LCD screen.
Reseting the Timer:
To reset the Timer back to Factory Default Settings, use a small
object such as paper clip or the tip of a pen and press and release
the "R" button located just below the LCD Screen. The display will
flash indicating a reset.