Owners manual

Updated 13/DEC/01 BRH
2002 Energy Suspension. All rights reserved.2002 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R
17
0
8
0
3-27-02
INSTRUCTION SHEET FOR SET #3-4137
Read this instruction sheet thoroughly before initiating any work!
NOTE: When disassembling the body mounts, be sure to note the
number and position of shims that may have been used to align
the body. These shims will have to be reused to retain proper body
alignment.
CAUTION: Remove all the body mount bolts on one side of the
vehicle. Loosen but do not remove all the body mount bolts on
the opposite side of the vehicle. Only raise one side of the vehicle
at a time, lifting the body only high enough to remove/replace the
mounts. Always watch the fan shroud, brake lines, and various
hoses for sufficient clearance when raising the body. When jacking
the body, use a 2x4 or equivalent to spread the weight. Never
place jack faces directly on body panels!
When all mounts and hardware are installed, torque all bolts to
factory specifications.
Position #1
No mounts used,
washer only. Shim
as necessary.
Position #2
1. Supplied 3” washer
2. 4112 (with nipple)
3. Frame
4. Supplied sleeve (1-7/8” long)
5. 4062
6. Supplied 2-1/2” washer
Use supplied 9/16” x 5” bolt
Position #3
1. Supplied 3” washer
2. 4062
3. Frame
4. Supplied sleeve (2-1/2” long)
5. 4009
6. Supplied 2” Washer
(Use ½” x 5” bolt )
1
2
4
3
5
6
Revise
d by NJT
Must reuse original hardware
(When specified)
Parts Diagram
(Refer below)
1
2
3