Owners manual

6
5
4
3
2
1
1
2
3
4
5
4 DOOR
2 DOOR
Spray all nuts to be removed generously with your favorite rust
buster.
Note: When disassembling, note the quantity and positions of any shims
that may have been inserted for body alignment. These shims will have to
be reused to insure proper body alignment.
Remember: Only raise body high enough to remove & replace mounts.
Always watch the fan shroud for sufficient clearance when raising the
body. When jacking the body use a long enough 2X4 or 4X4 for maximum
support. Never put jack directly on body panels.
Install mounts one side at a time with bolts on other side loosened only.
Retorque to factory specs.
Removal
Set # 3-4132
17075
U vpdated 24/No /08 NK
1131 VIA CALLEJON, SAN CLEMENTE, CA
R
Updated 13/DEC/01 BRH
2002 Energy Suspension. All rights reserved.2002 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
4068
4067
It is recommended that if you are unfamiliar with this type of work that you refer to a qualified service center specializing in this type of work. It is
also recommended that if you choose to do this work yourself that a factory service manual be obtained for the proper procedures pertaining to
removal, replacement and proper torque specifications for your vehicle. This instruction set is intended as a guideline for the safe installation of
Energy Suspension’s polyurethane bushings, once you have removed the factory components from your vehicle.
Must reuse factory
hardware.
6
5
4
3
2
1
1
2
3
4
5
4 DOOR
2 DOOR
Spray all nuts to be removed generously with your favorite rust
buster.
Note: When disassembling, note the quantity and positions of any shims
that may have been inserted for body alignment. These shims will have to
be reused to insure proper body alignment.
Remember: Only raise body high enough to remove & replace mounts.
Always watch the fan shroud for sufficient clearance when raising the
body. When jacking the body use a long enough 2X4 or 4X4 for maximum
support. Never put jack directly on body panels.
Install mounts one side at a time with bolts on other side loosened only.
Retorque to factory specs.
Removal
Set # 3-4132
170 57
Upda d 24 Nov/0 Nte / 8 K
1131 VIA CALLEJON, SAN CLEMENTE, CA
R
Updated 13/DEC/01 BRH
2002 Energy Suspension. All rights reserved.2002 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
4068
4067
It is recommended that if you are unfamiliar with this type of work that you refer to a qualified service center specializing in this type of work. It is
also recommended that if you choose to do this work yourself that a factory service manual be obtained for the proper procedures pertaining to
removal, replacement and proper torque specifications for your vehicle. This instruction set is intended as a guideline for the safe installation of
Energy Suspension’s polyurethane bushings, once you have removed the factory components from your vehicle.
Must reuse factory
hardware.