Owners manual

Must reuse original hardware
Instruction sheet for
Set # 3.4124
80-91 Suburban 2WD & 4WD
Note: It is recommended that this set be professionally installed if you are unfamiliar with this type of
work, and a factory service manual be purchased prior to performing any work on your vehicle for
proper disassembly, reassembly and torque specs. These instructions are intended for bushing removal
and install of Energy Suspension polyurethane bushings, once you have removed the factory
component from your vehicle.
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R
Position # 4 & 6
1. Body.
2. -0-
3. 4034
4. Frame.
5. -0-
6. -0-
Position # 5
1. Body.
2. Factory washer.
3. 4010
4. Frame.
5. 4026
6. Supplied washer.
Position # 1, 2 & 3
1. Body.
2. Factory sleeve.
3. 4067
4. Frame.
5. 4068
6. Factory washer.
2
3
1
4
5
6
Parts Diagram
NOTE: When disassembling the body mounts, be sure to note the number and position of shims that may have been used to
align the body. These shims will have to be reused to retain proper body alignment.
CAUTION: Remove all the body mount bolts on one side of the vehicle. Loosen but do not remove all the body mount bolts on
the opposite side of the vehicle. Only raise one side of the vehicle at a time, lifting the body only high enough to remove/replace
the mounts. Always watch the fan shroud, brake lines, and various hoses for sufficient clearance when raising the body. When
jacking the body, use a 2x4 or equivalent to spread the weight. Never place jack faces directly on body panels! When all mounts
and hardware are installed, torque all bolts to factory specifications.
17038
15/NOV/10 BRH
17038
15/NOV/10 BRH
Grill and headlight doors
must be removed for access
to bolt for position # 1
Updated 8/JAN/03 BRH Updated 23/JAN/04 BRH
Updated 14/JAN/05 BRH Updated 10/JAN/06 BRH
Updated 2/JAN/07 BRH
2008 Energy Suspension. All rights reserved.2008 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
4
1
2
3
5
6
7
Position # 7
1. Body.
2. Factory sleeve.
3. 4059
4. Frame.
5. 4026
6. Supplied washer.