Owners manual

INSTRUCTION SHEET FOR SET #3-4116 & 3-4121

Updated 13/DEC/01 BRH

May not be reproduced, in any form, or by any means,

without the written consent of Energy Suspension.

1131 VIA CALLEJON, SAN CLEMENTE, CA 92673

Must re-use original hardware.

17023

2-4-05

Read this instruction sheet thoroughly before initiating any work!

Mount

Position

Diagram

NOTE: When disassembling the body mounts, be sure to note the

number and position of shims that may have been used to align the

body. These shims will have to be reused to retain proper body

alignment.

CAUTION: Remove all the body mount bolts on one side of the

vehicle. Loosen but do not remove all the body mount bolts on the

opposite side of the vehicle. Only raise one side of the vehicle at a

time, lifting the body only high enough to remove/replace the

mounts. Always watch the fan shroud, brake lines, and various

hoses for sufficient clearance when raising the body. When jacking

the body, use a 2x4 or equivalent to spread the weight. Never place

jack faces directly on body panels!

When all mounts and hardware are installed, torque all bolts to

factory specifications.

Positions #1-2-3-4

(Position #3 used on crew cab only)

1. Body

2. Factory Sleeve

3. 4067

4. Frame

5. 4068

6. Factory Washer

Install mounts one side at a time with

bolts on other side loosened only.

Grill and headlight doors must be

removed for access to bolt for position #1

POSITIONS #1 - #4

21/JAN/2016 MAX ECN 16006