Owners manual

Position # 2 & # 3
Position # 1
Parts Diagram
(refer below)
17013
7/DEC
/00
BRH
1
2
3
6
1
3
2
5
4
6
Must re-use original hardware
4
Set # 3-4101
Removal
Spray all nuts to be removed
generously with your favorite rust
buster.
Note: When disassembling, note the
quantity and positions of any shims that
may have been inserted for body
alignment. These shims will have to be
reused to insure proper body alignment.
Remember: Only raise body high
enough to remove & replace mounts.
Always watch the fan shroud for sufficient
clearance when raising the body. When
jacking the body use a long enough 2X4
or 4X4 for maximum support. Never put
jack directly on body panels.
Install mounts one side at a time with
bolts on other side loosened only.
Retorque to factory specs.
POSITION # 3
1. Body
2. Factory sleeve
3. 4003
4. Frame
5. 4004
6. Factory washer
POSITION # 2
1. Body
2. Factory sleeve
3. 4005
4. Frame
5. 4004
6. Factory washer
POSITION # 1
1. Factory washer
2. 4002
3. Core support Bracket
4. 4001
5. Factory sleeve
6. Frame
Mount Position
Diagram
1
2
3
5
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R
2000 Energy Suspension. All rights reserved. 2000 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.