Owners manual

#1
#2
#3
#4
#5
#6
#7
#8
#9
Updated 1/FEB/02 BRH
2015 Energy Suspension. All rights reserved.
C
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
17P17635 Page 2 of 3
03/DEC/14 BEL ECN# 14054
Position Number and Bushing Location
R
PLEASE READ ALL INSTALLATION TIPS BEFORE REMOVING ANY ORIGINAL BODY MOUNTS!
ŸInstallation:
ŸUse the illustrations on pages 2 and 3 to position all the mounts in their proper locations.
ŸUse Silicone RTV or any other flexible adhesive to adhere the bottom side of the body mount bushings in
positions #2, #3, #5, #7, & #8 to the frame. Make sure the surfaces on the frame are clear of any dirt and oil before
setting mounts in place. Note the orientation of the #2 position mount in the diagram above.
ŸUse the new bolts supplied in the kit to align the mounts in the #1 and #9 positions, but do not tighten until the
body has been lowered back on the frame.
ŸAfter the body has been lowered back onto the new mounts, begin torquing all mounting bolts to 15-25 lb-ft in
positions #1, #4, #6 and #9.
ŸCheck and tighten up the heater core hoses if previously loosened.
ŸRe-attach the front brake line bracket to the fender and torque bolts to 5-7 lb-ft.
ŸRe-attach the fuel filler neck hose and breather hose to the filler neck ports and tighten hose clamps back in place.
ŸReinstall front plastic grille and verify all mounting nuts and bolts have been tightened correctly.
ŸThe new bushings will take a few 100 miles of driving before completely settling in their positions and it
is highly recommended to recheck all mounting nuts and bolts to their proper torque values.
Installation Instructions
For set # 1.4101
1986-1995 Suzuki Samurai
Body Mount Set
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
Customer Service: [phone]
Toll Free Customer Service: [phone]
Email Support: [e-mail]
Position 2
Positions 5, 7 & 8
Position 3
Body
Frame
Silicone RTV
04P04340
04P04341
04P04335
FRONT
REAR