Instruction Manual

8/10 energysistem.com
FM radio
Before using the FM radio function, it is necessary to carry out a search of all stations available. The radio stations will
be saved to the speaker's internal memory. It is therefore not necessary to carry out a new search each time you switch
it on. You will only have to do this if you place the device in a new location or if you change the frequency of the saved
radio station.
To carry out a search of all radio stations, press Playback mode/Voice assistant (4) until the FM radio mode appears on
screen. Press and hold Playback mode/Voice assistant (4) for 2 seconds to carry out an automatic search. The process
may take a few minutes.
Once the search has been completed, press and hold Volume +/ Next (2) or Volume -/ Back (3)* to select the station
you want to hear from all saved radio stations. Press the very same buttons to turn the volume up or down.
Press On/Off/Play/Pause/Calls (1) to mute the radio. Press the very same button to unmute.
If you place the speaker somewhere else, you will have to carry out a new search to obtain a proper radio wave
reception.
Your Urban Box 3+ saves the last selected radio station when you turn it off. This way you will hear it when switching on
the speaker once again.
Important: The battery charging process may interfere with radio signals depending on the AC/DC power adapter
used.
Auxiliary audio input
Your Urban Box 3+ features an Auxiliary audio input (10) to connect your external devices using an audio cable with 3.5
mm mini jack plug.
Important:
-It is not possible to control music playback from the speaker while using this mode. You will have to use the connected
music player instead.
-The maximum volume depends directly on the power of the signal transmitted by the source device.