User's Manual

3434
≥ Restart the device by pressing the Reset button.
≥ As last resource we recommend you to update the firmware with the last version
available in our website.
Battery capacity seems short:
≥ The battery was not used for a long time. Please charge the device completely.
≥ The battery is not fully charged. Please charge the device for aproximately 5 hours.
Cannot read/open en ebook:
≥ Check if the ebook format is supported by device.
The device cannot be operated during micro USB connection
≥ The device cannot be operated while it is transferring data to a computer to prevent
any damage on reader internal memory or micro SD/SDHC card.
Micro SD/SDHC card is not being detected:
≥ After inserted a micro SD/SDHC card, if your device is has no response, please take
out and insert again.
≥ Do not remove micro SD/SDHC card or turn off during data writing or reading to
prevent damage to data and your device.
≥ Make sure the micro SD/SDHC card is unlocked before writing or deleting data in
the micro SD/SDHC card.
≥ Backup your files and data before formatting the micro SD/SDHC card. Please
format the micro SD/SDHC card in FAT/FAT32.
≥ Your eReader only can read micro SD/SDHC cards up to 32 GB.
Why do some EPUB documents not look right on my Energy Book?
≥ Many publishers and convert software are supporting this format, but without
maintaining a single standar set. One of the most common problems is when the
creator puts everything EPUB e-book content in a “chapter” in EPUB. This can
cause the document reading differs with formatted text, margins, gaps, etc.
Can I listen music while reading?
≥ Yes, except in PDF format.
FIRMWARE UPDATE
To update the firmware of your Energy™ eReader, visit our download section in our
website: http://www.energysistem.es/es-en/support.
You will find all the files and instructions needed to update successfully your device.