Installation manual

20.0 Required Warranty Information
Installing Electrician: Fill out applicable information on this page.
1. Strategy selected (check applicable strategy):
Fixed Rotating Combination
Control Household Circuit Priority Minimum On/Off
Circuit Assignment/Description (if applicable) Time
1 ___________________________________ ______________ mins on ____ /off ____
2 ___________________________________ ______________ *mins on ____ /off ____
3 ___________________________________ ______________ *mins on ____ /off ____
4 ___________________________________ ______________ mins on ____ /off ____
5 ___________________________________ ______________ mins on ____ /off ____
6 ___________________________________ ______________ mins on ____ /off ____
7 ___________________________________ ______________ mins on ____ /off ____
8 ___________________________________ ______________ mins on ____ /off ____
9 ___________________________________ ______________ mins on ____ /off ____
10 ___________________________________ ______________ mins on ____ /off ____
11 ___________________________________ ______________ mins on ____ /off ____
12 ___________________________________ ______________ mins on ____ /off ____
13 ___________________________________ ______________ mins on ____ /off ____
14 ___________________________________ ______________ mins on ____ /off ____
15 ___________________________________ ______________ mins on ____ /off ____
16 ___________________________________ ______________ mins on ____ /off ____
*Control Points 2 and 3 are shipped with 8 minutes on and 5 minutes off. See Appendix B, page for instructions.
Owner:
1. Record circuit assignments above and in the space provided on the keyboard label of the Control/Display Unit.
2. Fill out Warranty Card and mail today!
3. Record items 5 through 8 from Warranty Card below for your records.
Date of installation Serial number
Installing Electrical Contractor Phone #
4. Fill in current system settings.
27
•
Load priorities
•
Load control strategy selected
•
Household circuit or load assignments
•
Minimum On/Off-Times for all circuits if changed,
otherwise write zero.
•
Date of installation
•
Name of Energy Sentry Dealer or installing electrical
contractor.
•
Complete the War ranty Card and drop in mail to Brayden
Automation Corporation 6230 Aviation Circle, Love-
land, CO 80538. The Warranty Card must be sent in for
proper registration of unit. Warranty is not valid unless
the Warranty Card has been received and unit has been
registered.
19.7
Leave the owner’s manual in a convenient location
near the Control/Display Unit. If install is new construction,
place manual in kitchen drawer with appliance manuals.
19.8
This concludes the installation of the Energy Sentry
9312 Demand Management System.
Thanks for choosing Energy Sentry!