Installation manual
2
Maximum Value Feature
All of the model 9312 units are automatically installed with the Maximum Value feature
included. The Maximum Value feature gives you three times the on-peak limit for greater
exibility of electrical usage during “off-peak” hours. Use as much electricity as you want
in off-peak. You still pay the lower total usage rate, with no penalty for a higher demands.
Your savings can be substantial. If you have any questions on the Maximum Value feature,
call your local BHP ofce and we will be glad to assist you.
HOW TO OPERATE YOUR DEMAND CONTROLLER
Power Available
When the LED numbers in the “circuit on” area are lit, there is power available to that
assigned load. Each number represents a relay that controls one or more assigned loads.
When the number is not lit, power is unavailable.
The circuit assignment numbers should be recorded on the inside of the control panel
door at the time of installation. A record of the loads controlled should be documented
and led in the back of your Installation Manual which was supplied by the electrician
during installation.
Each number represents a relay that can switch up to two circuits at a time.
Your demand controller will control up to 16 points in the “circuit on” area. Older units only
had 8 points.
If the display LED’s are not lit, check the appropriate 15 amp breaker in the main circuit
panel to see if it is on. If power is on and the LED’s are still not lit call your local BHP ofce
for service.