User manual

System Installation
Step 1: Attach the Display Unit to a power supply socket.
Use the power adapter to attach the Display Unit to a power supply socket nearby. After being connected to power
supply, the LCD screen of the Display Unit will display as below right photo, where the “Energy Now” value is
dashes.
Now keep the Display Unit powered on at all times.
Step 2: Make the 1-way Power Transmitter start to work
Keep the Transmitter as close to the Display Unit as possible. Pull out the clear plastic tab (marked with
“REMOVE BEFORE USING”) from the back of the transmitter. The tab is an insulation sheet, once it is pulled out,
the built-in batteries will make the transmitter start to work immediately.
Step 3: Pairing of the Display Unit with the Transmitter
Press the UP/DOWN key of the Display Unit to choose the coding channel (CH01-CH15, beside the CLOCK
symbol) which is to be used to pair with the transmitter, for example, in below photo, CH03 is chosen as the
channel number.