Specifications

ManualsBrandsEnergizer ManualsMP3 PlayerHAWK

INTRODUCTION

Quick-Connect Type Connection P/N 10026542, Hansen

Threaded Type Connection P/N 10026543) when installed

on an MMR Air Masks are approved for use as a combi-

nation apparatus. When installed on an SCBA, that SCBA

becomes a combination-type apparatus for respiratory

protection during entry into and escape from oxygen-defi-

ient atmospheres, gases, and vapors when not more

han 20 percent of the cylinder’s rated capacity is used

uring entry.

Air Hose: When used as a combination apparatus, the

device shall be supplied with respirable air through air

supply hose with a minimum length of 8 feet and maxi-

mum length of 300 feet within the pressure range of 85-

90psig. A maximum of 12 sections of straight or uncoiled

air supply hose may be used in making up the working

length of hose. When using coiled hose, a maximum of 6

sections may be used and each section is considered to

be 50 feet long. Hose sections vary from 8 feet to 100 feet

lengths. The air-line connection to the apparatus is to be

made through approved Quick-Disconnects only. The

purity of the air supply is the responsibility of the user. The

respirator is approved only when the air supplied meets

the requirements of the Compressed Gas Association

Specification G-7. 1989 quality verification level (Grade) D

for Gaseous Air.

Do not Transfill (be a Donor) using a 3000psi URC

Assembly. The 3000psi URC Assembly has a check

valve that does not allow cylinders to Transfill (be a

Donor). Failure to follow this warning can result in

serious personal injury or death.

Using the 3000psi URC Assembly to fill cylinders, the

cylinder can only be filled to 2216psig. If the pressure

exceeds 2216psig a relief valve in the URC Assembly

will vent at approximately 2525psig or as low as

2400psig. A 3000psig cylinder can only be filled to

3000psig by using a secondary air source; the 3000psi

URC Assembly can not be used for filling a 3000psig

cylinder. Failure to follow this warning can result in

serious personal injury or death.

Use with adequate skin protection when worn in gases

and vapors that poison by skin absorption (for example:

hydrocyanic-acid gas). In making renewals or repairs,

parts identical with those furnished by the manufacturer

under the pertinent approval shall be maintained. NIOSH

Appr

oval Information for non CBRN approved r

espirators

is included as a supplement to these instructions (P/N

10024128).

Approval for use against CBRN chemical warfare agents

is maintained only when using approved components and

following instructions listed on the NIOSH approval sup-

plement (P/N 10044165).

IMPORTANT NOTICE FOR RESPIRATORY PROTEC-

TION PROGRAM ADMINISTRATORS

1. An adequate respiratory protection program must

include knowledge of hazards, hazard assessment,

selection of proper respiratory protective equipment,

proper facepiece sizing and fit testing, instruction and

training in the use of equipment, inspection and main-

tenance of equipment, and medical surveillance. [See

OSHA regulations, Title 29 CFR, Part 1910. 134 (c).]

2. This SCBA may be used only after proper instruction

and training in its use as specified in NFPA-1500 and

OSHA regulations Title 29 CFR, Part 1910. 134.

3. This SCBA must be secured by a positive mechanical

means if stowed within an enclosed seating area of

fire department vehicles, or in a compartment with a

positive latching door. The method of holding the

SCBA in place must be designed to minimize injury to

persons in the vehicle in the event of accident, rapid

deceleration, or acceleration.

4. Do not mark the SCBA, i.e., with stamps, labels, paint,

or other method. Use of such markings may interfere

with apparatus use or may constitute a flammability

hazard.

5. Be sure that no other equipment interferes with the

SCBA facial seal, or with the user’s hands, or other

necessary means of mobility. For more information on

self-contained breathing apparatus use and perfor-

mance standards, please consult the following publi-

cations:

NFPA Standar

d 1500, Fir

e Department Occupational

Safety and Health Programs (Chapter 5) and NFPA 1981

Standard, on Open-Circuit SCBA’s for Fire Service. Above

publications are available fr

om the following: National Fire

Protection Association, Batterymarch Park, Quincy, MA

22269.

ANSI Standard Z88.5, Practices for Respiratory Protection

for the Fire Service; and, ANSI Standard Z88.2, Practices

for Respiratory Pr

otection. American National Standar

Institute, 1430 Broadway, New York, NY 10018.

OSHA Safety and Health Standards (29 CFR 1910) (see

specifically Part 1910. 134), available from the

Superintendent of Documents, U. S. Gover

nment Printing

Office, Washington, DC 20402. Compressed Gas

Association, Inc., 1725 Jefferson Davis Hwy., Suite 1004,

Arlington, VA 22202.

AL 606 (L) Rev. 16 - 10023638

WARNING