Certificate

00-IC-F0056 – Issue 13.0 This certificate may only be reproduced in its entirety and without any change, schedule included. Page 1 of 2
[1] EU-TYPE EXAMINATION CERTIFICATE
e
[2] Equipment or Protective System intended for use
in Potentially Explosive Atmospheres
Directive 2014/34/EU
[3] EU-Type Examination Certificate Number: DEMKO 08 ATEX 0803999X Rev. 2
[4] Product: Headlight, Model MSHD3AA
[5] Manufacturer: Eveready Battery Company Co. Inc.
[6] Address: 533 Maryville University Drive, P.O. Box 411460, St. Louis, MO 63141 USA
[7] This product and any acceptable variation thereto are specified in the schedule to this certificate and the documents therein referred to.
[8] UL International Demko A/S, notified body number 0539 in accordance with Article 17 of the Council Directive 2014/34/EU of 26 February
2014, certifies that this equipment or protective system has been found to comply with the Essential Health and Safety Requirements
relating to design and construction of equipment and protective systems intended for use in potentially explosive atmospheres given in
Annex II to the Directive.
The examination and test results are recorded in confidential report no . 4787053865
[9] Compliance with the Essential Health and Safety Requirements has been assured by compliance with:
EN 60079-0:2012+A11:2013 EN 60079-11:2012 EN 60079-28:2015
[10] If the sign "X" is placed after the certificate number, it indicates that the equipment or protective system is subject to special conditions for
safe use specified in the schedule to this certificate.
[11] This EU-Type Examination Certificate relates only to the design and construction of the specified product. Further requirements of the
Directive apply to the manufacturing process and supply of this product. These are not covered by the certificate.
[12] The marking of the equipment or protective system shall include the following:
e I M2/II 1G Ex ia op is I/IIC T4
Certification Manager
Jan-Erik Storgaard
This is to certify that the sample(s) of the Equipment described herein (“Certified Equipment”) has been
investigated and found in compliance with the Standard(s) indicated on this Certificate, in accordance with the
ATEX Equipment Certification Program Requirements. This certificate and test results obtained apply only to
the equipment sample(s) submitted by the Manufacturer. UL did not select the sample(s) or determine whether
the sample(s) provided were representative of other manufactured equipment. UL has not established Follow-
Up Service or other surveillance of the equipment. The Manufacturer is solely and fully responsible for
conformity of all equipment to all applicable Standards, specifications, requirements or Directives. The test
results may not be used, in whole or in part, in any other document without UL’s prior written approval.
Date of issue: 2009-01-12
Re-issued: 2016-06-07
Notified
Body
UL International Demko A/S, Borupvang 5A, 2750 Ballerup, Denmark
Tel. [phone], [e-mail], www.ul.com