User guide

5 While still holding the
plunger rod, flip the vial
over so the vial is on top,
slowly pull down on the
plunger to fill the
reservoir.
6 Gently tap the side of the
reservoir to make any air bubbles
rise to the top of the reservoir.
7 Slowly push up on the plunger
just enough to remove any air
bubbles from the reservoir.
8 Slowly pull down on the plunger
to fill the reservoir to the number
of units desired.
9 To avoid getting liquid on the top of the
reservoir, flip the vial over so that it is upright.
Turn the reservoir counter-clockwise, then pull
straight up to remove the reservoir from the
transfer guard.
10 Place the tubing connector onto the
reservoir. Turn the connector clockwise, pressing
gently against the reservoir until you feel it slide
in. Push in and continue turning until the reservoir
and the connector lock with a click.
“Click”
Starting on insulin60