User guide

To use the remote control, these pump settings must be programmed:
• Remote Options = On
• Remote control ID code entered in pump (code is on back of remote)
•Easy Bolus = On
Turn on remote control option
WARNING: If there is a LOW BATTERY condition, the pump will not receive signals from the remote. To
ensure the pump communicates with the remote control, make sure the pump does not have a low
battery. (Replacing the low battery with a new battery will restore remote control function.)
1 Go to the REMOTE OPTION screen.
Main > Utilities > Remote Option
2 Select On, then press ACT.
3 The REMOTE ID MENU screen appears. Add, delete or review your remote ID as described in the next
section. Exit the menus if you are done.
Add, delete, review remote control IDs
Each remote control has its own unique ID. Up to three different remote control IDs can be programmed in
your pump. The remote control programming screens are very similar to those for the meter. Make sure to
select Remotes when programming your remote control.
If you are not sure that your remote control ID is entered in your pump, check the REVIEW REMOTE ID
screen. You must turn on the remote option to add, delete or review the remote control ID(s) programmed
in your pump.
1 Adding a remote ID
a. Select Add ID, then press ACT.
b. Enter each of the six ID numbers found on the back of the remote control. Press ACT after each
entry.
After you set the last number of the ID, the screen will return to the REMOTE ID MENU.
2 Deleting a remote ID
a. Select Delete ID, then press ACT.
b. Select the remote ID that you want to delete, then press ACT.
The selected ID is now deleted.
Utilities118