User guide

Starting on insulin 49
Manual prime
Manual prime fills the infusion set tubing with insulin before you attach it to the infusion site.
Manual prime is only available after you rewind your pump.
1 After you rewind your
pump, the PREPARING
TO PRIME screen will
appear.
WARNING: Make sure the infusion set is disconnected from your body before you press
ACT to prime the pump. Never insert the reservoir into the pump while the
tubing is connected to your body. Doing so could result in an accidental
infusion of insulin.
2 Press and hold ACT to
start the prime. The
pump will beep 6 times
indicating the prime has
started.
3 While you hold ACT, the
pump will beep again 6 times
as the screen begins counting
the prime units being used.
4 Continue to hold ACT until
insulin droplets form on the tip
of the infusion set needle, then
release. Be sure no bubbles are
in the tubing.
WARNING: If the PRIMING-HOLD ACT screen does not display, do NOT continue. Do NOT
insert the infusion set into your body. Please contact the 24 Hour HelpLine for
assistance.
Take care to remove any air bubbles during the manual prime.
PREPARING TO PRIME
Disconnect from Body
Insert/Lock Reservoir
Hold ACT to Prime
The pump may automatically return to the HOME
screen while you install the reservoir. Press ACT to
return to the PREPARING TO PRIME screen.
ACT
(hold)
PREPARING TO PRIME
DISCONNECT
Hold ACT
ACT
(hold)
PRIMING – HOLD ACT
ESC if
done
U
0.3
ACT
(hold)