Operation Manual

User Manual
!
>> assembly and activation >> 006
Assembly and activation
Connecting the computer
Data cable: Connect the data cable coming from the equipment with the
one coming from the computer [1].
Mounting:
Attach the computer to the mount on the equipment. Carefully
slide the insert sleeve on the back of the computer over the mount on the
centre post [2].
Pay attention not do damage the data cable when sliding the computer
housing over the mount.
Then you fasten the four xing bolts [3].
Hand pulse sensors: Plug the hand pulse cable into the connector on the
back of the computer [4].
Power supply: The computer gets its power supplied through the data cable
of your equipment. Note: the equipment has to be plugged in and turned
on.
Computer activation
The computer can be activated by pressing any key or when the user starts
to pedal.
Start, control and signals
The computer starts with a short beep tone and the standard settings. The
program 1 (Manual Program) is displayed.
The user can start to input his settings.
Sleep mode
Should the E-104 not receive a signal for more than 4 minutes it changes into
the sleep mode. The display turns dark. To start again press any key or start
to pedal.
If the computer does not receive a signal
for more then 4 minutes the sleep mode is
activated.
1 2 33 4
S T O P PROGRAM
L E V E L
T I M E R P M
A G E
O D O W A T T H E A R T R A T E