Operation Manual

User Manual
>> service >> 036
Service
Troubleshooting
Error message
E1: The computer receives no signal from the motor or the signal is
interrupted.
E2: There is no connection between the power board and the computer
or the power board is defective.
E4: The computer receives no signal during the BMI-BMR-Body Fat
Measurement test mode.
Solution:
see “The computer display is not working“.
The computer display is not working
•
The computer might not be getting power. Check all connections and
cables.
• If all connections are in order and you still have no read out on the display
please contact your local ENERGETICS-dealer.
Heart rate (PULSE) is incorrect or not displayed at all.
M
onitoring via the hand pulse sensor:
• Check if your hands have proper contact with the sensors. Both hands have
to be placed on the sensors simultaneously. There might be a slight delay
before the read out appears.
• Check all cable connections.
• Try moistening your hands slightly if they are very dry.
Monitoring via the chest strap (optional):
• Not all available chest straps are compatible with the E-104. Check if your
chest strap runs on a frequency of between 5,4 – 5,7 Hz.
• The battery of the chest strap is too weak and needs replacing.
The computer has shut down
I
n rare cases the computer might shut down, mainly because of sudden
changes in the electrical current or static discharge. Normally the E-104
restarts on its own.
Should this not occur restart the computer by pulling the power plug, wait a
few seconds then reinsert it.
Care
Take care that to avoid any moisture penetration. Clean the computer with a
lightly dampened cloth. Do not use abrasive cleaning solutions.
Maintenance
There is no need for special maintenance. Regularly check that all bolts and
connections have a tight t. Exchange any defective parts immediately. For
assistance contact your local ENERGETICS-dealer.