Operation Manual

User Manual
>> service >> 028
Service
Troubleshooting
Error message
ERR: The computer receives no signal during the Recovery Program
or
the computer receives no signal during the BMI-Body Fat
Measurement test mode.
E1: The computer receives no signal from the motor or the signal is
interrupted.
ERR2: There is no connection between the power board and the computer
or the power board is defective.
Solution:
see “The computer display is not working“.
The computer display is not working
•
The computer might not be getting power. Check all connections and
cables.
• If all connections are in order and you still have no read out on the display
please contact your local ENERGETICS-dealer.
Heart rate (PULSE) shows no or incorrect read out
•
Check if your palms have proper contact with the sensors. Both palms have
to be in contact with the sensors simultaneously. The display may be on a
slight delay.
• Check all cable connections.
• Try moistening your hands if they are dry.
The computer has shut down
I
n rare cases the computer might shut down, mainly because of sudden
changes in the electrical current or static discharge. Normally the E-103
restarts on its own.
Should this not occur restart the computer by pulling the power plug, wait a
few seconds then reinsert it.
Care
Take care that to avoid any moisture penetration. Clean the computer with a
lightly dampened cloth. Do not use abrasive cleaning solutions.
Maintenance
There is no need for special maintenance. Regularly check that all bolts and
connections have a tight t. Exchange any defective parts immediately. For
assistance contact your local ENERGETICS-dealer.