Use and Care Manual

P a g e | 6
25 DO NOT cover the unit with any type of cloth while in operation or until fully cooled.
26. DO NOT wrap the power cord around the unit.
27. PLEASE HANDLE THE UNIT WITH CARE.
28. DO NOT operate the heater if the wall outlet is damaged or after a heater malfunction, if it has been dropped or has
been damaged in any manner.
29. DO NOT USE THE UNIT AS A ROOM HEATER.
30. Do not run the power cord under carpeting; do not cover the cord with throw rugs, runners or the like. Arrange the
cord away from traffic area where it may be tripped over.
31. To disconnect the heater, turn the power switch to off, then unplug the unit.
32. To prevent possible fire, do not block air intakes or exhaust openings in any manner. Do not use on soft surfaces, like
a bed, where openings may become blocked.
33. This unit is intended for household use only. DO NOT use the unit in such areas as construction sites, greenhouses,
barns or stables or any place that has flammable materials.
34. ‘SAVE THESE INSTRUCTIONS’
5. FCC INSTRUCTIONS
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult EnerG+® at 1-866-967-7333 ext 227.
6. CLEANING AND STORAGE
1. Turn the unit OFF and unplug the unit before cleaning.
2. Use only a soft cloth to clean the exterior. An air compressor or a vacuum cleaner can be used to clean the
interior.
3. Do not use gasoline, paint thinner or other chemicals to clean the heater
4. Store the heater in its original box and store in a cool, dry place.
NOTE: If you experience a problem, please call our EnerG+® customer service department at 1-866 967-7333 ext 227. Do
not attempt to open the heater housing by yourself. Doing so may void your warranty and cause damage to the heater
or personal injury,
7. SPECIFICATIONS
Power supply: 120V / 60Hz
Wattage: 1500Watts
Product Box Dimensions: 890 x 410 x 1850 mm
Net Weight: 21,3 Kg
G.W.: 25,8 Kg