Instructions / Assembly

2
1. Please empty the packing box thoroughly, and make sure that there are no missing parts.
2. DO NOT PLUG THE UNIT IN UNTIL THE UNIT IS COMPLETELY ASSEMBLED. MAKE SURE THERE IS NO DAMAGE TO THE
UNIT AND POWER CORD.
IF THERE IS ANY DAMAGE OR IF THERE ARE MISSING PARTS, PLEASE CONTACT 1-866-967-7333.
2. ASSEMBLY
Parts: 1 X Heater Head
2 X Hollow Tubes
2 X M4*8 screws
1 X Weighted Base
Screw the bottom hollow tube on the weighted base.
Screw the middle tube with the lower tube.
Place the heater head power cord through the hollow tubes and base as much as possible.
Pull the power cord gently out of the base as much as possible. Fix the power cord under the weighted base
using the supplied 4pcs M4 nuts.