Use and Care Manual

P a g e | 4
12. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable
liquids are used or stored.
13. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause
fire, electric shock, or injury to persons.
14. Always plug heaters directly into a wall outlet receptacle. If you must use an extension cord, the cord should be at
least NO .14 AWG and rated for no less than 1875 W.
15. ONLY USE THE HEATER ON SOLID, STABLE AND FLAT GROUND.
16. This heater is not intended for use in bathrooms, laundry areas or similar indoor locations. Never place heater where
it may fall into a pool, bathtub or other water receptacle.
17. Use the unit in a well ventilated area.
18. A heater has hot, arcing and sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids
are used or stored.
19. Do not move the unit when it is still connected to an electrical outlet and always wait for the unit to cool down
before moving, cleaning and storing.
20. Do not touch the heater when in use. Please wait at least 10 minutes before touching it.
21. Extreme caution is necessary when any heater is used near a child or someone with a physical disability.
22. DO NOT LEAVE THE UNIT UNATTENDED WHEN IN OPERATION.
23. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handles (not provided)
when moving this heater, Keep combustible materials such as furniture, pillows, bedding, papers, clothes, curtains or
any object at least 3 feet (0.9m) from the front of the heater at any time.
24. DO NOT cover the unit with any type of cloth while in operation or until fully cooled.
25. DO NOT wrap the power cord around the unit.
26. PLEASE HANDLE THE UNIT WITH CARE.
27. DO NOT operate the heater if the wall outlet is damaged or after a heater malfunction, if it has been dropped or has
been damaged in any manner.
28. DO NOT USE THE UNIT AS A ROOM HEATER.
29. Do not run the power cord under carpeting; do not cover the cord with throw rugs, runners or the like. Arrange the
cord away from traffic area where it may be tripped over.
30. To disconnect the heater, turn the power switch to off, then unplug the unit.
31. To prevent possible fire, do not block air intakes or exhaust openings in any manner. Do not use on soft surfaces, like
a bed, where openings may become blocked.
32. This unit is intended for household use only. DO NOT use the unit in such areas as construction sites, greenhouses,
barns or stables or any place that has flammable materials.
33. ‘SAVE THESE INSTRUCTIONS’
5. CLEANING AND STORAGE
1. Turn the unit OFF and unplug the unit before cleaning.
2. Use only a soft cloth to clean the exterior. An air compressor or a vacuum cleaner can be used to clean the
interior.
3. Do not use gasoline, paint thinner or other chemicals to clean the heater
4. Store the heater in its original box and store in a cool, dry place.
NOTE: If you experience a problem, please call our EnerG+® customer service department at 1-866 967-7333 ext 227. Do
not attempt to open the heater housing by yourself. Doing so may void your warranty and cause damage to the heater
or personal injury,