Use and Care Manual

P a g e | 2
1. A cross type screwdriver (not included) is necessary for the installation. Take out the Allen Key from the packaging.
2. Read this instruction manual carefully before installation and use. Keep this instruction manual in a proper and safe
place for future use in case needed.
Installation:
1. Put the heater upside down (Fig.A). Slide the stainless oval washer (#2) onto the base bracket (#1).The smooth
side should be upside down
2. Slide the base cover (Fig.B)and (#3) into the base bracket (#1)
3. Slide the base (#4) into the base cover (Fig.C)
4. Insert the round washer (#6) onto the base (#4) and insert the crews (#5 M6*20). Screw on tight with the
provided Allen Key.
5. Attach the holding collar around the power cord and screw it under the base with the cross type screwdriver
(not included).