Installation Guide

• Connect your auxiliary battery positive cable, which is to be 50mm2 (0AWG), to the back of
the Inverter circuit breaker on the same side as the copper bus bar using an 8mm ring
terminal.
• Finally connect the positive cable to the battery followed by the negative cable to the battery
using correctly sized ring terminals, in the case of an Enerdrive Lithium battery use 8mm ring
terminals.
Note: No other connections are to be direct to the battery as this will result in incorrect reading on the
Simarine system.
Note: Due to the Inverter requiring grounding it is important to ensure that there is an electrical connection
from the inverter ground terminal to the vehicle’s chassis, this can be made through the main DC cable
connections.
Temperature Sensor
• The supplied temperature sensor, plugged into the Simarine SC301 shunt, can be located in
your desired location such as canopy space, fridge or freezer.
Note: Do not cut or extend the temperature sense cable as this may result in inaccurate readings.
Inverter Input and Output AC Wiring
Caution: AC wiring is only to be performed by a licensed electrician, please check your local state or
territories requirements.
Simarine Settings
Your Simarine will come with basic set up completed, however if you wish to add or customise any settings
please refer to the supplied Simarine manual.
INSTALLATION GUIDE
Connect main positive cable from
auxiliary battery here.