Installation Guide

ManualsBrandsEnerdrive ManualsChargingEnerdrive Wanderer Power System - 1600W Combi with 40A AC Charger and 40A DC-DC Charging

POWER SYSTEM SERIES

Installation Guide

!"#$%&'('(

Congratulations on the purchase of The Wanderer power system from Enerdrive. This all-in-one system

was designed for those who want the best charging, power supply and monitoring package in one

compact easy to install package. Your system includes the following individual products:

• Enerdrive DC2DC40+ DC Battery Charger

• Enerdrive ePRO 1600W/60A Combi Inverter Charger

• Simarine Pico Monitor with SC301 Shunt and additional SCQ50 shunt

The following guide is for the installation of the pre-assembled power system, for speciﬁcs on each

product please refer to the individual product manuals supplied or online at www.enerdrive.com.au.

Summary of content (8 pages)

PAGE 1
POWER SYSTEM SERIES Installation Guide !"#$%&'('( Congratulations on the purchase of The Wanderer power system from Enerdrive. This all-in-one system was designed for those who want the best charging, power supply and monitoring package in one compact easy to install package.
PAGE 2
INSTALLATION GUIDE Mounting • Choose the location of The Wanderer with focus on keeping the battery as close as possible (less than 1.5m is ideal) to the system. If the distance from the battery to The Wanderer is greater than 1.5m, larger diameter cable than the supplied 50mm2 will be required. • Consideration must be given to avoid moisture and excessive dust.
PAGE 3
INSTALLATION GUIDE • Connect the negative wire from your lights, pumps, and other accessories to the system by connecting directly to the negative bus bar using 4mm ring terminals. If you have a larger load circuit (over 30 amps) we recommend to connect the negative directly to the Main negative Bar. Connect negative wire from accessories to this busbar.
PAGE 4
INSTALLATION GUIDE Connecting to Main (Start) Battery • Connect the Battery Input terminals of your DC2DC+ to your vehicles main/start battery. A 70A midi fuse located as close as possible to the main/start battery is required. Refer below cable sizing chart.
PAGE 5
INSTALLATION GUIDE • Connect your auxiliary battery positive cable, which is to be 50mm2 (0AWG), to the back of the Inverter circuit breaker on the same side as the copper bus bar using an 8mm ring terminal. Connect main positive cable from auxiliary battery here. • Finally connect the positive cable to the battery followed by the negative cable to the battery using correctly sized ring terminals, in the case of an Enerdrive Lithium battery use 8mm ring terminals.
PAGE 6
INSTALLATION GUIDE
PAGE 7
INSTALLATION GUIDE
PAGE 8
INSTALLATION GUIDE Speciﬁcations Output Current Maximum: 40~50A Solar Input Voltage: 14.5-45VOC DC Charger Solar Wattage Maximum: ≤23V Input, 500W (600W allowable), ≥37.