User Manual

DC LOADS +
EN3TOR-G2
Set DipSwitch to: Standard Program
12/12/2018
GREEN
BLUE
BLACK
RED
WHITE
YELLOW
Inverter +
Inverter -
DC LOADS +
COMMON NEG
Lithium Setup - ePOWER Dual 12v - 2018-G2
SR-TS-TOR-G2
SR-TS-TOR-G2 Wire to: RTS Terminal
1A
10A
NOTE:
Long term storage switch.
Only turn this switch OFF once the batteries are fully charged, the Yellow Latching Relay is disengaged and all charging sources have been shut down correctly.
Enerdrive has provided this drawing as a guide only and installers must ensure the system is installed to the local requirements for fuse protection and wire sizing. If you have any questions please call; Enerdrive on 07 3390 6900
Temp Sensor
5A
Optional Cabinet Fan Output 4 Turns on when Temp Sensor >35
°C
EN3TOR-G2 Plug into BTS
EN3TOR-G2 Plug into BTS
GREEN
BLUE
BLACK
RED
WHITE
YELLOW
EPL-ABS
Battery +
Battery -
+
-
Battery +
Battery -
RED
BLUE
WHITE
YELLOW/GREEN
BLACK
+
-
RED
BLUE
WHITE
YELLOW/GREEN
BLACK
EPL-ABS
Voltage Protection Circuit
Battery Connection
Balancer Link N/A
Voltage Protection Circuit
Battery Connection
Balancer Link N/A
2
1
2
1
3
3
Min 95mm Cable with a Max length of 1.5m from Battery to Connection Board.
2
Battery cables must be of equal length and size between Batteries and busbars to keep the batteries balanced.
1.Voltage protection circuit must be connected prior to connecting the Battery connection Plug. 2. Never disconnect Battery connection wires from the battery while the lead is connected to the EPL-ABS box. 3. Only connect Balance wire once Battery Conection wires and plugs are connected.
WARNING!
EPL-ABS