User Manual

Enerdrive ePRO Inverter / Charger Owners Manual
Page 34
Mode indicator
LEDs ‘inverter
on’, ‘charger on’
and ‘AC in’ are
blinking red
once per second
(battery error).
Battery voltage is too low (<
8V@12V or <16V@24V).
Battery is damaged, replace it.
Or battery has been discharged
too extremely, let it slowly
recover to above 8.5V so that the
transfer switch and charger can
startup to recharge the battery.
Battery voltage is too high
(>16.5V or >33V@24V).
Check the DC system for an
external source that pushes
the battery voltage too high.
Too high ripple voltage on DC
input. (manual restart needed)
Check battery wire connections.
Decrease battery cable
length. Increase battery and/
or cable size. Make sure that
no other equipment on the
same battery is generating
a high ripple voltage.
Only mode
indicator LED
‘inverter on’
blinks red once
per second.
Battery voltage is too low
(<10V@12V or <20V@24V).
Apply mains voltage to
the AC input and start
charging the battery.
When another turn o voltage
is desired in ‘Battery protect On’
mode, please use Dashboard
Only mode
indicator LED
‘inverter on’
blinks red twice
per second.
Inverter is overloaded. Make sure that the total power
rating of the AC output load
is lower than the nominal
inverter power rating.