User Manual
Page 11
Enerdrive ePRO Inverter / Charger Owners Manual
3.2 Factory Default Parameter Settings
The table below shows an overview of the most relevant factory
parameter settings, as stored in the ePRO Combi. These settings are
based on an average application. Enerdrive cannot guarantee that these
are correct for your specic application. Please check all parameters
carefully, especially the battery charging voltages.
Parameter Inverter frequency
Value 50Hz
Description Output frequency in inverter mode. Can be set to 50Hz or 60Hz
Congurable by DIP switch (DIP 2) and Dashboard
Parameter Inverter voltage
Value 230V
Description Output voltage in inverter mode. Can be set from 200V to 240V
Congurable by Dashboard
Parameter Low Battery Protect
Value On
Description Enables or disables low battery protection with user programmable
shutdown, restart and delay values (standard respectively 10V, 12V
and 5 seconds). Turning Low Battery Protect o, results in immediate
inverter shutdown when the battery voltage is less than 8.0V.
Congurable by DIP switch (DIP 3) and Dashboard
Parameter Automatic Stand By (ASB)
Value O