User Manual

Enerdrive ePRO Inverter / Charger Owners Manual
Page 10
3. Conguring The Enerdrive ePRO Combi
3.1 General
The ePRO Combi can be congured in two ways. Using the DIP switches
located in the connection bay, a small selection of basic settings can
be made. In most cases this will be sucient to quickly setup the unit
for typical applications. Another option is to setup the ePRO Combi
using the Dashboard for Windows software. This software is included
in the optional ePROLink to USB Communication Kit (part.# 5092120),
which also contains an isolated interface box required to connect the
ePRO Combi to a PC. Using Dashboard, all available parameters can be
edited, and it is also possible to edit or create your own battery charge
programs.
CAUTION
When conguring the ePRO Combi by Dashboard, make sure that DIP
switch 1 is set to ON (External). When set to ON, all remaining DIP switch
settings (2 up to 7 or 9) are ignored and the ePRO Combi will always load the
parameter settings as congured in Dashboard.
When DIP switch 1 is set to OFF (Local) again, DIP switch 2 up to 7 or 9
are overriding the corresponding parameter settings previously made in
Dashboard. The parameters that cannot be congured by DIP switches,
shall return to the factory default settings.
This manual will only describe the DIP switch settings and all relevant
factory default parameters. Conguration by ePRO Dashboard will be
explained in the ePRO Dashboard manual that comes with the ePROLink
to USB Communication Kit.