Installation Manual

ManualsBrandsEnerdrive ManualsBatteries & Power SystemsThe Archie Portable Power System

POWER SYSTEM SERIES

Installation Guide



Congratulations on the purchase of your Archie power system from Enerdrive. This all-in-one system

was designed for those who want the best charging, power supply and monitoring package in one

compact portable package. Your system includes the following individual products:

• Enerdrive 12V 100AH eLITE Lithium Battery (Optional 12V 125AH B-TEC Lithium Battery)

• Enerdrive DC2DC40+ DC Battery Charger with Blue Anderson vehicle charge input and Red

Anderson solar charge input.

• Enerdrive ePOWER 600W Inverter

• Enerdrive ePRO PLUS Battery Monitor

• 2 x Twin USB Outlets, 3 x DC Outlets, 2 x 50A Anderson Style Outlets

Summary of content (8 pages)

PAGE 1
POWER SYSTEM SERIES Installation Guide Congratulations on the purchase of your Archie power system from Enerdrive. This all-in-one system was designed for those who want the best charging, power supply and monitoring package in one compact portable package.
PAGE 2
INSTALLATION GUIDE Mounting • • • • • • Consideration must be given to avoid moisture and excessive dust. If you choose to fix Archie into a semi permanent location use the supplied mounting brackets. Slide each bracket into the slots located on the front and back of Archie. Use appropriate fasteners for the material the brackets will be fastened into. It is recommended where possible use a bolt and nut (nutsert or similar) especially if you are planning on frequent removal.
PAGE 3
INSTALLATION GUIDE Solar Connection • Using a genuine "red" Anderson plug, connect your unregulated solar panels directly into Archie. Use of portable folding panels are recommended when Archie will be used in a portable application. When installed in a vehicle the use of fixed panels may be preferred. Refer to the Specifications table for maximum solar panel rating. Connecting to Main (Start) Battery • • Using the optional Vehicle Charge Cable Kit connect the lug end to your main/start battery.
PAGE 4
INSTALLATION GUIDE Battery Reset Archie is fitted with a Battery Reset switch. This allows a flat battery to be "jump started" from the main/start vehicle battery, when connected. 1. Turn off ALL DC and AC loads 2. Ensure the "DC2DC" circuit breaker on the back of Archie is turned on. 3. Ensure the blue "Vehicle Input" plug is connected to Archie and the vehicle is running. 4. Hold the green “Reset” button on the back of Archie for 5-10 seconds. 5. Release and wait 10seconds 6.
PAGE 5
INSTALLATION GUIDE Archie - Enerdrive Wiring
PAGE 6
INSTALLATION GUIDE Archie - Capabilities Portable Regrigerator Battery Charger Mobile Phone Vehicle Start Battery GoPro Air Compressor 240W Folding Solar Panel Kit
PAGE 7
INSTALLATION GUIDE Output Current Maximum: 40~50A DC Charger Solar Input Voltage: 14.5-45VOC Solar Wattage Maximum: ≤23V Input, 500W (600W allowable), ≥37.5V-45V Input, 750W (800W allowable) AC Output: 230V 50Hz Inverter Battery AC Output Power: 600W Cont (900W Surge) Standard - 12V 100Ah LiFeP04 Optional - 12V 125Ah LiFeP04 with Bluetooth monitoring Dimensions General Weight 470L x 265W x 415H (without brackets) 490L x 265W x 415H (with brackets) 25.0KG (with 100Ah eLITE) 28.
PAGE 8
ENERDRIVE PTY LTD P.O. Box 9159, Wynnum Plaza, Queensland, Australia 4178 Ph: 1300 851 535 / Fax: 07 3390 6911 Email: support@enerdrive.com.au Web: www.enerdrive.com.