User Manual

Section 2 - Charging
Lithium batteries need to be charged slightly differently to other batteries.
To ensure they live a long life and provide maximum capacity, you must use a charger with a lithium
setting - this includes:
AC Chargers
DC to DC Chargers
Solar Controllers
If your charger allows, set the charge voltage from 14.2 - 14.6 Volts and Float 13.5 - 13.6 Volts. and proceed
with charging. We recommend charging at the lower end of the voltage scale for maximum longevity of
the battery.
It is recommended that the charging current should be 60 Amps or less. You can charge at higher currents,
but 60 Amps or less is recommended. See
Section 9 - Battery Specifications.
*Note:
You can charge a lithium battery with a non-lithium charger, but these chargers can deliver too much or
too little voltage and may not cut off when the battery is full.
DO NOT use a charger with a “Pulse Stage” or “Equalisation Mode”. This will damage the battery and void
warranty.
DO NOT connect this battery to a start battery with a VSR (Dual Battery System or “Voltage Sensitive Relay”).
The voltage of the Lithium battery may keep the VSR switched on resulting in it discharging into the start
battery.
Page 5
Enerdrive B-TEC EPL-200BT-12V-G2 Manual (Rev. 2.0)