User Manual

Section 9 - Battery Specifications
www.enerdrive.com.au Page 12
12.8V
≥2000 Cycles
0 - 45˚C
3.75 ± 0.03V
3.60 ± 0.05V
Discharge below release voltage
200A @ 25˚C
±5˚C for 30 mins
-20˚C - 60˚C
11.0 - 14.60V approx.
450A for 1.0s
12.8V per cell
14.20 -14.60
13.50 -13.60
150A @ 25˚C for
30mins
≤60A
200Ah
Enerdrive B-TEC 12v-G2 Lithium Battery Technical Data
EPL-200BT-12V-G2
The battery is supplied with a LiFePO4 Battery Management System (BMS)
that can monitor and optimise each single prismatic cell during charge &
discharge, to protect the battery pack from overcharge, over discharge &
short circuit. Overall, the BMS helps to ensure safe and accurate operation
of the battery.
Over-Discharge Protection
Over-Discharge Protection Per Cell 2.80V ± 0.05V
Protection to 65˚C ± 5˚C
Protection to 50˚C ± 5˚C
Protection to 55˚C ± 5˚C
Protection to 45˚C ± 5˚C
Auto release after 5s
L 505mm L 505mm
W 173mm W 176mm
H 265mm H 276mm
Approx. 25.0kg
≤3% per month
≤30 days - 20˚C to 35˚C, 45% to 75% RH
≥30 days - 10˚C to 30˚C, 45% to 75% RH
5s Auto Release
Disconnect Load
220A for 30s -
450A for 1s
3.20V ± 0.05V
Apply Charge/Voltage ≥12.8v
Over-Discharge Release Per Cell
Over-Discharge Release Method
Over Current Protection
Discharge Over Current
Protection Reset Time
Over Current Release Method
Over Temperature Protection
Battery Discharge Over Temperature
Battery Charge Over Temperature
Short Circuit Protection
Mechanical Characteristics
Without Tray
& Strap
With Tray
& Strap
Dimensions
Weight
Storage Information
Temperature & Humidity Range
Self-discharge Rate
Q: Can I series connect B-TEC batteries to achieve higher voltage?
A: No. Enerdrive offers higher voltage Lithium solutions - contact us for details.
Q: Can I use an Inverter with my B-TEC battery?
A: Of course! We recommend an inverter size of 2000 watts or less on the EPL-200BT-12V-G2.
Q: Can I install the B-TEC battery in a wet area?
A: It is not recommended - the best environment is a dry, cool, well ventilated area.
Q: Can I install the B-TEC battery on its side or end?
A: No.