Manual
WARNING
• Enerdrive recommends that all wiring be done by a skilled technician to ensure adherence to the best
practice standards for on-board DC electrical installations. Failure to follow these instructions can
damage the unit and could also result in personal injury or loss of life.
CAUTION
• Before Beginning Your Unit Installation, Please Consider The Following:
• The unit should be used or stored in an indoor area away from direct sunlight, heat, moisture
or conductive contaminants. Do not install the ePOWER Industrial Battery Charger in corrosive
environments.
• When placing the unit, allow a minimum of 75mm of space around the unit for optimal ventilation.
2. PRODUCT DESCRIPTION
The Enerdrive ePOWER Industrial Battery Charger package includes the items listed below.
• ePOWER Industrial Battery Charger
• IEC 240Vac Power Lead
• Waterproong grommet for Power Lead
• Owner’s manual
3. OPERATION ILLUSTRATION
LED Indicators and Fault Signals
LED Indicators during start up:
In order to nd out the installed charging prole in the unit, please follow the steps below.
1. Make sure the DC cables are not connected to the battery.
2. Connect the AC input to the charger and switch on.
3. The charger LED display panel will indicate the battery charge algorithm prole installed.
Page 7www.enerdrive.com.au