Owner's Manual

WARNING

• Enerdrive recommends that all wiring be done by a skilled technician to ensure adherence to the best

practice standards for on-board DC electrical installations. Failure to follow these instructions can

damage the unit and could also result in personal injury or loss of life.

CAUTION

• Before Beginning Your Unit Installation, Please Consider The Following:

• The unit should be used or stored in an indoor area away from direct sunlight, heat, moisture

or conductive contaminants. Do not install the ePOWER Industrial Battery Charger in corrosive

environments.

• When placing the unit, allow a minimum of 75mm of space around the unit for optimal ventilation.

2. PRODUCT DESCRIPTION

3. INSTALLATION

The Enerdrive ePOWER Industrial Battery Charger package includes the items listed below.

• ePOWER Industrial Battery Charger

• IEC 240Vac Power Lead

•

• Owner’s manual

4. OPERATION ILLUSTRATION

LED Indicators during start up:

LED Indicators and Fault Signals:

1. Make sure the DC cables are not connected to the battery.

2. Connect the AC input to the charger and switch on.

www.enerdrive.com.au

Page 7

• This charger is to be installed in a cool and well ventilated location.

• Although certain models are waterproof, it is recommended to install in a dry location.

• When using in a ﬁxed installation use suitable fasteners (screws or bolts) to secure the

charger to a solid surface that can handle the weight and forces when the vehicle is

moving.