Owner's Manual

10. CHARGE PROFILE

NOTE: You will require a formatted (FAT32) USB memory stick with a capacity of 1024KB or

larger.

1. Download and save the Battery Algorithm Listing from the download link www.enerdrive.

com.au/Algorithm/ePOWER-algorithm.xlsx

Listing” tab in this spreadsheet.

5. Make sure the charger is NOT connected to the battery or AC power.

6. Unscrew the round cap covering the USB port on the front of the charger and insert the

USB memory stick.

7. Plug the AC power cord into the charger and switch ON AC power.

8. Please allow up to 1 min for programming. Programming is complete once USB status LED

is “SOLID”.

9. Switch OFF AC power to the charger.

10. Remove USB memory stick and screw USB cap back on.

11.

Battery Capacity LED’s. See user manual for explanation.

12. Switch OFF AC power to the charger.

13. Connect the charger to the DC battery.

14.

batteries please contact Enerdrive.

PLEASE NOTE:

Page 18

Enerdrive ePOWER Industrial Battery Charger Owner’s Manual (Rev. 1.7)