Owner's Manual

WITH DIGITAL DISPLAY
www.enerdrive.com.au
Page 15
Blinking
Frequency
The battery is not connected or the battery
is in reverse or the battery is damaged
1) Check battery connection is correct.
2) Check charger connection is correct.
3) Check each battery is good.
E01 bAt
E02 AC
E03 Hot
E04 bAt
E05 Err
E06 bAt
Abnormal AC Power Input (Voltage)
Charger High Temperature Protection
Battery High Temperature Protection
Internal error in product Return to the factory for repair.
1) Check AC input cord is connected between
charger and AC outlet.
2) Make sure AC plug is tightly inserted into AC outlet.
1) Charger shuts down and enters protection mode due
to charger/environmental temperature is too high. Please
place the charger in a well ventilated environment.
2) Disconnect the charger and wait for 15-20 mins before
reconnecting for charging.
1) Charger will reduce output current and stop charging
when the battery temperature exceeds 50°.
2) When the battery temperature drops, the charger will
reset automatically.
Battery Voltage is too high
Check and assure that the correct output battery voltage
is connected.
Fault Cause Solution