Owner's Manual

Image refers to EPI-4860
AC Input
DC Battery Connection
Brake Switch
Red = Positive
Black = Negative
White = Temp. Sens
When AC has power - open circuit
When AC has NO power - closed circuit
Charger Switch
Remote LED
Open circuit - charger ON
Closed circuit - charger OFF
1
2
3 54
4
5
1
2
3
Always connect the positive cable to the battery first, then the negative cable to the negative (chassis for
negative grounded vehicles) prior to connecting to supply mains.
After charging, and when removing charger, always disconnect the battery charger from the supply mains, then
disconnect the negative/chassis connection and then the positive connection.
Supply mains wiring in fixed installs such as caravans or similar vehicles must be in accordance with the
national wiring rules.
www.enerdrive.com.au
Page 13
6. MAINTENANCE INSTRUCTIONS
1. Do not expose the charger to oil, dirt, mud or direct heavy water spray when cleaning vehicle.
2. The enclosure of the charger has been tested successfully to EN60529, meeting IP66
compliance.
3. If the detachable AC input power supply cable is damaged, replace with a cable that is a
detachable cable, 3 conductor, 1.5 mm² minimum, and rated appropriate for use in the country of destination.
AC input type to the charger is, type IEC 60320 C14 plug.
safety approved