User Manual

Read the owners manual carefully before installing the EN-DCMOTION-L.
Description
The EN-DCMOTION-L is a motion activated LED lamp for 12 and 24 Volt systems for which a Passive Infa-Red Detector is used.
The EN-DCMOTION-L has a built in high eciency Power LED (1 Watt). The EN-DCMOTION-L is designed for indoor use only. This
could be for example cargo space of a truck, a bus or inside a ship. To prevent over-voltage and overload the EN-DCMOTION-L
possesses, besides the basic functionality, also some protection functions.
MOTION ACTIVATED LED LAMP INSTALLATION GUIDE - EN-DCMOTION-L
Unit 11, 1029 Manly Road Tingalpa, Queensland, Australia 4173 Ph: 1300 851 535 / Fax: [phone] Email: [e-mail] | Web: www.enerdrive.com.au
Specications
Description Value
Auto 12 V / 24 V detection
Switch OFF delay: 5 Min.
Power up delay: +/- 30 sec.
Detection angle: 60°H - 60°V
Detection range: 5 meter
Dimensions L 67 * W 50 * H 30 (mm)
Weight 107 gr including cable.
Cable length 2 meters
Other technical details
Description 12 V 24V
Power LED 1 Watt
Eciency ± 90%
Softstart LED 5 seconds
LED Colour 4000K
Low Voltage disconnect 10.5 V 21 V
Low Voltage disconnect delay 5 seconds
Turn on Voltage, after low Voltage
disconnect
12.6 V 25.2 V
Current consumption (idle state) 3 mA
LED (on) current ± 100 mA ± 56 mA
Over Voltage turn o 16.0 V 32.0 V
12 / 24 V
BATTERY
EN-DCMOTION-L
WHITE
BLACK
LED
Operation
The EN-DCMOTION-L switches the LED on as soon as motion is
detected. If no motion is detected any more, the EN-DCMOTION-L
switches o with a dely.
Connecting
1. Connect the minus ( - ) of the batter to the white cable.
2. Connect the plus ( + ) of the batter to the black cable.
ATTENTION!
Do not open the EN-DCMOTION-L when the input voltage is
connected.